When you are using a spotter you should back the ambulance?

When you are using a spotter, you should back the ambulance no faster than: Average walking speed! Jenna is driving her ambulance at 30 mph on a road covered with ice.

Where should a spotter stand while backing an ambulance?

The spotter should be in a visible safe zone positioning him/herself ten (10) to fifteen (15) feet at the left rear of the ambulance.

When entering a turn you should reduce centrifugal force by?

When entering a turn, you should reduce the centrifugal force acting on your vehicle by:

  1. Slow down, shift to a lower gear, and do any braking before you enter the curve.
  2. Entering the curve towards the right edge of the roadway to avoid any potential conflicts with oncoming traffic.

Where is the driver-side pivot point on a Type 2 ambulance?

Back of the wheel well is the driver-side pivot point located on a Type II ambulance. This answer has been confirmed as correct and helpful.

Where is the driver-side pivot point located on a Type I ambulance?

At the center of the rear hubcap is where the driver-side pivot point located on a type 1 ambulance. At the center of the rear hubcap is where the driver-side pivot point located on a type 1 ambulance. This answer has been confirmed as correct and helpful.

IT IS INTERESTING:  What is the symbol on the side of an ambulance?

How fast can an ambulance go through an intersection?

Do not exceed 20 mph and in congested intersections travel at 2-3 mph (remember, traffic is coming from your left and you are in the oncoming lane of traffic; you have shortened the reaction and braking distance of both vehicles substantially.

What is the 4 5 12 rule Evoc?

According to the 4-5-12 rule, what is the following distance he must maintain? 5 seconds!

What happens when the centrifugal force increases?

Increasing the mass or decreasing the radius increases the centrifugal force in direct or inverse proportion, respectively, but increasing the speed of rotation increases it in proportion to the square of the speed; that is, an increase in speed of 10 times, say from 10 to 100 revolutions per minute, increases the …

What happens if you break during a curve?

Braking on a curve may cause you to skid. Reduce speed before entering the curve, and slowly lighten the pressure on the brake until reaching the apex point (where the car is closest to the inside of the curve line).

Why is it important to slow down when driving around a curve?

Any speed or steering adjustments required while in the curve should be very gradual to avoid losing control of your vehicle. The most important part of driving a curve or corner is to slow down before you get to it.

What is the pivot point of a Type 2 ambulance?

Pivot point is the center of the rear axle on both sides, unless your driving something with dual rear axles, then it’s the center of the space between the axles. The spotter should be in a visible safe zone positioning him/herself ten (10) to fifteen (15) feet at the left rear of the ambulance.

IT IS INTERESTING:  Do you pay for ambulance in USA?

What is Type 2 ambulance?

Type II ambulances are built using a van-type chassis, with a raised roof being the only major modification to this vehicle beyond a standard van. Type II ambulances are mostly used by hospitals and health organizations to transport patients who require basic life support features.

Ambulance in action