What is the best place for a spotter to stand in an ambulance?

The spotter should be in a visible safe zone positioning him/herself ten (10) to fifteen (15) feet at the left rear of the ambulance.

When you are using a spotter you should back the ambulance?

When you are using a spotter, you should back the ambulance no faster than: Average walking speed! Jenna is driving her ambulance at 30 mph on a road covered with ice.

Where is the driver-side pivot point located on a Type I ambulance?

At the center of the rear hubcap is where the driver-side pivot point located on a type 1 ambulance. At the center of the rear hubcap is where the driver-side pivot point located on a type 1 ambulance. This answer has been confirmed as correct and helpful.

Where is the driver-side pivot point?

Pivot point is the center of the rear axle on both sides, unless your driving something with dual rear axles, then it’s the center of the space between the axles.

Where is the driver-side pivot point located on a type II ambulance?

Back of the wheel well is the driver-side pivot point located on a Type II ambulance.

IT IS INTERESTING:  Best answer: How many paramedics work in Ontario?

How many seconds should a car be behind a big truck?

Did You Know? If you are driving below 40 mph, you should leave at least one second for every 10 feet of vehicle length. For a typical tractor-trailer, this results in 4 seconds between you and the leading vehicle. For speeds over 40 mph, you should leave one additional second.

What is Type 2 ambulance?

Type II ambulances are built using a van-type chassis, with a raised roof being the only major modification to this vehicle beyond a standard van. Type II ambulances are mostly used by hospitals and health organizations to transport patients who require basic life support features.

What is driving with due regard?

Due regard can be defined as driving in a manner to avoid any predictable collision. As noted above, the emergency vehicle driver must provide adequate warning to others by using the warning devices, and by controlling their speed to allow other motorists time to react to their warning.

When entering a turn you should reduce centrifugal force by?

When entering a turn, you should reduce the centrifugal force acting on your vehicle by:

  1. Slow down, shift to a lower gear, and do any braking before you enter the curve.
  2. Entering the curve towards the right edge of the roadway to avoid any potential conflicts with oncoming traffic.

Where should a spotter stand?

The spotter should stand approximately 8-10 feet away from the vehicle.

Which is true with respect to passing another vehicle?

Passing should be done in the right lane is true with respect to passing another vehicle. This answer has been confirmed as correct and helpful.

IT IS INTERESTING:  Your question: What is the French word for ambulance?
Ambulance in action